Fish Display

General care of the fish display

  • Read and follow all safety instructions and warnings before using the display. Failure to do so could result in costly damage.
  • This display is intended for aquatic animals and plants.
  • Do not use abrasive products to clean the display (glass and aluminium).
  • Do not handle sharp or rigid objects near the aquariums, as this can cause serious damage to them.
  • Do not handle or make any changes to the display if you are not qualified to do so.
  • When handling the display, do so without water.
  • The stand is intended for indoor use only.
  • Keep the technical parts of the display out of the reach of children.

Aquarium care

  • Do not use sharp or rigid objects when working on aquariums.
  • Do not clean with abrasive products.
  • Whenever the system is working, do not obstruct any water inlet or outlet.

Decanter care

  • Do not use sharp or rigid objects when working near the decanter.
  • Do not clean with abrasive products.
  • Do not block any water inlets or outlets when the system is running.
  • Check the water level regularly.
  • Check the operation of the pump regularly.
  • Check that all electrical equipment is properly connected..
  • Before using electrical equipment, consult the relevant manuals

Cleaning and maintenance

Aquarium drainage


  • Aquarium drainage


  • The connection pipe to the sewage system must be correctly connected before proceeding with any drainage work.
  • Check that the valves are properly closed after draining.

Water outlet from aquariums for decanting/strong>


  • Return of aquarium water to the decanter.


  • Regularly check the condition of the filter bag (aquarium waste).

Water outlet from aquariums for decanting


  • Return of water from the decanter to the aquariums by a circulation pump.


  • Before starting operation, always check that the water level in the decanter and aquariums is adequate.
  • Check that the flow control valves are fully open before connecting the pump. Fail- ure to do so could damage the pump.

Water circulation by UV


  • Passage of water through UV


  • To allow water to pass through the UV light, first fully open the exhaust valves and close the full flow control valve.
  • To stop using the UV light, first disconnect the UV light, then open the full flow control valve and finally close the bypass valves.